Oil seals are vital to the daily operation of most factories and a wide range of industrial and commercial equipment. They are available in imperial and metric dimensions for both single- and double-lip design. Motors, Mechanical Hydraulic systems, pistons, and pumps utilize oil seals to protect internal components. Depending on the application, there are various material, size, and configuration options to best fit your needs. Learn more about oil seals, their composition, and the wide range of advantages they offer for your equipment.
Double metal cased
Does it mean the seal stops the leakage completely? Well, on the practical grounds yes because there is no ‘visible leakage’.
Smear clean engine oil on the pulley sleeve and seal, then refit the pulley with the key and keyway aligned. Tighten the bolt to the correct torque (consult a service manual or a dealer if in doubt).
Oil seals made of HNBR are characterised by excellent properties that include high resistance to mineral oils with additives, low steam and gas permeability, good cold flexibility down to -30 °C depending on type, good ozone resistance and friction resistance. HNBR seals withstand heat up to 150°C.
The spark plug is essentially a device that generates an electric spark to ignite the compressed air-fuel mixture inside the engine cylinder. This ignition process creates a small explosion, which pushes the piston down and ultimately drives the vehicle forward. Without spark plugs, the engine would not be able to start or run efficiently.