Stainless steel wire is characterized by good corrosion, in chemical plants or pharmaceutical industry can often be used to stainless steel wire, suitable for acid, alkali environment. Aluminum alloy wire is characterized by high temperature, can adhere to the high temperature of more than 100 degrees Celsius does not fade, and has good corrosion, patience is also very good. It can be used for device manufacturing in construction industry.
Out-of-line annealing means that the recrystallization annealing of hot or cold rolled steel plate is carried out in the bottom type annealing furnace or cover type annealing furnace before entering the hot plating wire line, so that there is no annealing process in the galvanized line. The steel plate must maintain a clean active surface of pure iron, free of oxides and other dirt, before hot dip galvanizing. In this method, the annealed surface oxide sheet is first removed by pickling method, and then coated with a layer of zinc chloride or a mixture of ammonium chloride and zinc chloride solvent for protection, so as to prevent the plate from being oxidized again.
Heavy duty hexagonal mesh made of steel wire by special machinery woven into a hexagonal mesh net. This kind of mesh can be cut and assembled into fence mesh, mountain hanging mesh, vegetation three-dimensional mesh, composite, etc. Aliases: Gabion mesh, heavy hexagonal mesh, ecological mesh, wire mesh, etc.
In general, the cost of hot dipping zinc is lower than that of other maintenance coatings. The reason is very simple. Other maintenance coatings, such as sand painting, are labor-intensive processes, whereas hot dipping zinc processes are highly mechanized and tightly controlled in-plant construction. Hot dip zinc coating can be visually and briefly tested for non-destructive coating thickness.
The temperature of large roll galvanized wire should be controlled at 30 to 50℃ during electroplating. Because the chloride ions in the bath are very corrosive, quartz glass heaters are generally used. Continuous production does not need heating, but needs cooling. Cooling can be in the groove side row thin wall plastic pipe, through the flow of tap water cooling, can also be used as a titanium pipe temperature control device.
In addition, before the wire enters the zinc liquid, a layer of insulation material containing zinc oxide reducing agent can reduce the heat loss and zinc ash floating. When the zinc solution contains 0.002%-0.005% aluminum, the brightness of the zinc layer can be increased obviously, and excessive zinc ash can be prevented from oxidation on the surface of the zinc solution.
Large hexagonal mesh called stone cage net, is mainly used for mountain protection, hydraulic construction and so on. Small wire hexagonal mesh is used as a good material for breeding, will twist twist hexagonal mesh in the welded iron frame on the hexagonal mesh welding into chicken coop, pigeon cage, rabbit cage cage cage, hexagonal mesh is the best material for breeding with a net.
The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.
Three points should be selected before installation, which are the highest point (lowest) and the side line on both sides. The number of thorn rope column is good. When installing, it can be installed gradually according to the hook arrangement of thorn rope column.Hot dip galvanizing of steel plate is also called hot dip galvanizing. Zinc ingots are melted in the tropics and some auxiliary materials are added in hot dip galvanizing. The steel grid parts are then soaked in a galvanizing tank and a galvanizing layer is attached to the steel plate. The strength of hot dip galvanizing depends on its corrosion resistance, and the adhesion and hardness of galvanized sheet are better. The amount of galvanized steel plate after galvanizing. So this is the general amount of zinc.
Due to the influence of production process or other factors, the zinc layer of galvanized wire products will be different to a certain extent, especially ordinary galvanized can not reach the beauty of electric galvanized, ordinary galvanized wire zinc layer is mainly for anticorrosion and corrosion prevention. Large volume galvanized wire products refers to the use of high quality low carbon steel, after drawing forming, pickling rust removal, high temperature annealing, hot dip galvanized, cooling and other processes, some galvanized wire products are made of iron wire galvanized.
The advantage of the steel mesh sheet is that the steel mesh sheet ensures the quality of the project and is made by the automatic and intelligent production line under the strict quality control of the factory. The mesh size, steel bar specifications and quality of the steel mesh are strictly controlled. Avoid artificial mesh leakage, bonding is not strong, bonding error and Jerry construction. The mesh steel has large rigidity, outstanding elasticity, uniform, accurate spacing and high welding point strength. Thus greatly improve the quality of the project.The wire used for barbed wire is woven or welded with low carbon steel wire, medium carbon steel wire, high carbon steel wire, stainless steel wire and other materials. The production process includes: general braid, embossed braid and spot welding. If the material is steel wire, after equipment processing into a network, it is called wire mesh.
4. When nothing happens, touch the cage in your hand. If your hands are dry, wipe them with an oilcloth and plate them. There are various ways to protect the structure of the cage from damage. The plate cage can improve the surface finish of the cage, and can eliminate the internal stress of part of the bird cage structure, so that the cage structure is gradually stable, reduce the possibility of deformation.
3. Salt water or alkali washing: In order to remove the residual acid in the dissolution tank, it is necessary to carry out salt water or alkali washing treatment on the steel wire to ensure that the surface of the steel wire is clean.
Heavy duty hexagonal mesh made of steel wire by special machinery woven into a hexagonal mesh net. This kind of mesh can be cut and assembled into fence mesh, mountain hanging mesh, vegetation three-dimensional mesh, composite, etc.